-
What is the thickest board that can be fabricated?
7.0mm -
What material types are kept in stock?
CEM-1, CEM-3, FR-4, High TG FR-4, PI (flex), Aluminum boards. -
What organization issued certification?
UL LLC (UL) -
What material types are you certified?
CEM-1, CEM-3, FR-4, High TG FR-4, PI (flex), Aluminum boards. -
What is the min soldermask dam?
0.10mm -
What are the soldermask relief annular ring requirements?
Large than copper pad 0.05mm each side. -
What is your soldermask registration?
1mil -
What is the smallest size?
0.15mm -
What is the smallest size that is not a cost driver?
>0.25mm -
What is the expected drill accuracy?
For the plating hole, the tolerance is +/-0.08mm, for the non-plating hole is +/-0.05mm, drill hole position tolerance is +/-0.08mm.